Lonewolf3165
Living the Dream!
I have this Daytona-Mig Plasma Cutter that I bought for home about 10+ years ago & it worked fine the few times I used it on some very small jobs, cut out a trunk floor & some other small jobs, so it's not like I have used it enough to wear out any of the consumable parts. But anyway I put the thing away in my dry garage & then went to use it about a year later & the damn thing wont work! It turns on but won't strike an arc. So I replaced all the nozzle tips & cups etc & still no good! Switch has continuity when closed. Does anybody know what goes wrong with these things just from sitting? I know it says Daytona-Mig on it but I'm told its an italian made unit by a company called Cebora. Daytona I'm told went the way of the Dodo bird. I'd like to get it working again if I can but don't want to keep throwing parts at it. I'm hoping some of you fabricator & welders might know what I can do. Thanks.