Problem Solved: Hellwig Sway Bar on an Early A....problem

-
My instruction pics shows vertical also but there’s no way it can. Right now with the 3 1/2 center link it’s not hitting but like I said he’s sending a 4 1/2 so I can see how it will look just below the LCA. That will definitely clear everything.
 
Tony Barracuda said:
My instruction pics shows vertical also but there’s no way it can. Right now with the 3 1/2 center link it’s not hitting but like I said he’s sending a 4 1/2 so I can see how it will look just below the LCA. That will definitely clear everything.
Click to expand...
Ok good luck
 
Tony Barracuda said:
My instruction pics shows vertical also but there’s no way it can. Right now with the 3 1/2 center link it’s not hitting but like I said he’s sending a 4 1/2 so I can see how it will look just below the LCA. That will definitely clear everything.
Click to expand...
So how did you make out with the new part?
 
I haven’t installed it yet. Was trying to get interior done. But that extra inch should put it right where it needs to clear everything and arm will be parallel with the ground.

IMG_1884.jpeg


IMG_1864.jpeg


IMG_1883.jpeg


IMG_1880.jpeg
 
Tony Barracuda said:
I haven’t installed it yet. Was trying to get interior done. But that extra inch should put it right where it needs to clear everything and arm will be parallel with the ground.

View attachment 1716232538

View attachment 1716232539

View attachment 1716232540

View attachment 1716232541
Click to expand...
Looking great. I’m still dealing with Kevin from Hellwig. I have small spots of interference, a bit of grinding to resolve but the angle of the endlinks is too much so I may take the bar to a suspension specialist and ask them about bending the bar to get the eyelets closer to the k member and away from the tires a bit. And this would make those end links go almost vertical.
 
You must log in or register to reply here.
-

Back
Top