QA upper control arm

[supertruck]

May have been covered before, but couldn't find it. Just installed a set of QA1 upper arms purchased from a member on my 73 Sport. I really like them but have a question. Should I ever need to replace the ball joint, what tool do I use? I have the special socket that PST sells and I used it on my stock arms. That tool has sidewalls that are too thick to fit the QAI arm. Anyone have their method? Thanks.

 

[moparmarks]

A press

 

[supertruck]

Believe these are screw in.

 

[moparmarks]

Actually you don't replace them, you rebuild them. You'll need their spanner tool to disassemble them.

 

[moparmarks]

You see where the spanner tool fits into the top piece.
Control Arms | QA1

 

[supertruck]

Mine doesn't have the fittings for that spanner. Looked up the part number and it's a standard screw in configuration with the top that takes the PST-type socket. I'll have to call the QA1 tech line.

 

[moparmarks]

When I stated "a press." before I actually meant to have a question mark after it. ?

 

[supertruck]

No problem. The ball joint has a part number by Pro Torque, I think it is. Looked up the part number and it's definitely a screw in.

 

[supertruck]

Correction. Proforged 101-10126.