elevensies
Well-Known Member
im bored doing the ''running in'' only 200 miles to go and its off for chassis dyno.
heres a vid from todays little outing
heres a vid from todays little outing
running in 340 swinger
- Thread starter elevensies
- Start date
-
elevensies
Well-Known Member
oh and its off for sign writing tomorrow :} scared
elevensies
Well-Known Member
[ame=http://i408.photobucket.com/albums/pp169/prideofthorne/dodge%20dart/IMG_2251_zpsc08340a9.mp4]
[/ame]
elevensies
Well-Known Member
yes its all solid mounts on engine, so i get some vibration lol
3'' to axle, no x or h pipes,
pumping 8lbs of fuel in :]
3'' to axle, no x or h pipes,
pumping 8lbs of fuel in :]
elevensies
Well-Known Member
coulpe of pics
Woods74
Broke Senior
lol
A break in period?
If a caveman did your machining that might be required. If machining was done with good tolerance controls and assembly, run it!
Do engines placed on a dyno go through a long break in period? Most only get a flat tappet break in, then get run hard. Roller cam stuff gets fired, with a light ring load and beat on.
It's not 1968...
If a caveman did your machining that might be required. If machining was done with good tolerance controls and assembly, run it!
Do engines placed on a dyno go through a long break in period? Most only get a flat tappet break in, then get run hard. Roller cam stuff gets fired, with a light ring load and beat on.
It's not 1968...
elevensies
Well-Known Member
crackedback, i agree, i was told to go gentle, so i am, i have about 80 miles on it now, so today
its avin it :violent1:
its avin it :violent1:
-
