Shifter cable trouble

[hippy 60]

I have a 63 Valiant that i put a 273 in it And found me a 65 trans. to go in it and i had everything changed so i could use the push button in it,I have everything in it and put a set of Doug's header's on it but now i don't have know good way to run the cable's does anybody have any idea how i can run them because the pipe's is right in the way.Thank's for any help

 

[Plymouth 65]

I installed a couple large wire loom holders to keep the shift cable away from the headers. Whatever route you choose don't kink the cable. 65'

 

[hippy 60]

I installed a couple large wire loom holders to keep the shift cable away from the headers. Whatever route you choose don't kink the cable. 65'

How did you run your cable's

 

[Plymouth 65]

Down the driver's side of the transmission. There should be a threaded standoff on the bell housing. I used that to mount the wire loom. Keep it tight against the firewall. 65'

 

[hippy 60]

Down the driver's side of the transmission. There should be a threaded standoff on the bell housing. I used that to mount the wire loom. Keep it tight against the firewall. 65'

 

[hippy 60]

I will try that and see,Thank's