[FOR SALE] Small block EFI intake manifolds (Mopar, Holley Street Dominator, Edelbrock)

-
Status
Not open for further replies.
furious70

furious70

Big Motor in a little car
Joined
Aug 26, 2008
Messages
78
Reaction score
24
Location
NW burbs of Chicago
Rating - 0%
0   0   0
Contact seller
Your choice $250 each + shipping. All were tested and used back in the day.


kw72pwp0zwxu3i_aeaqtk2-w383-h785-no-authuser-0-jpg.jpg

c5p6yxwnanq6a1v9pdaprm-w383-h785-no-authuser-0-jpg.jpg

eubhupguhlhdfcxxd_iba3-w383-h785-no-authuser-0-jpg.jpg
 
Dual plane, assuming ld340 but it's not cast into it. It is an old piece, converted in the 90's and ran as a carb years before.
Not sure on mopar, was there an m1 dual plane for sb?
 
furious70 said:
Dual plane, assuming ld340 but it's not cast into it. It is an old piece, converted in the 90's and ran as a carb years before.
Not sure on mopar, was there an m1 dual plane for sb?
Click to expand...
Yes, they made the m1 in both single and dual plane. Are they both 340/360 size ports?
 
And it’s hard to tell in that photo but is the Holley a street dominator or strip dominator?
 
And do you know if the injector spacing is the same as the magnum engines factory injector spacing?
 
That’s fine, I’m in no rush. If any of them match the magnum fuel rail spacing, I’ll buy that one. If none of them match, I’ll take either the m1 or the Holley
 
Holley intake is sold pending ship quote and payment.
Here's some more photos of measurements that are marked on the intakes

IMG_20230103_190642.jpg


IMG_20230103_190634.jpg


IMG_20230103_190629.jpg
 
Status
Not open for further replies.
-

Back
Top