[Found!] Solid Roller Lifters for A Engine

[GTX JOHN]

Looking for a full or partial set for an A Engine

 

[Demonracer]

I have a partial set, one of the has the pin that holds the roller messed up. PM me your email address and I'll send pictures later today.

 

[Moparpuller]

I have a set of comp solid rollers if interested. 2 pairs have some scouring

 

[GTX JOHN]

PMs sent.

I assembled my 318 SS engine and the full set of rollers that I
had were Shorter than I have had before, and did not think
it would matter.
However when I tried to put pushrods in, they hit on the top of the heads
where they mated to intake. The pushrod holes are huge in my heads and if
I clearance the top of head to fit the pushrods it would go entire through the top
of the head. I had to make a 8 inch set of pushrods for these rockers and the old
rollers only required about 7.3 something.

 

[SSG_Karg]

Just out of curiosity John, what brand are the short rollers?

 

[Ironmike]

I have a full set of Bamm rollers, modified for pushrod oiling, if interested. Think they have 1 summer in them.