kittypancake
Well-Known Member
Does anyone know what the "special tool" is to remove the tube seats from the master cylinder?
Special Tool?
- Thread starter kittypancake
- Start date
-
TrailBeast
AKA Mopars4us on Youtube
Tube seats?
The fitting that the line attaches to with it's fitting?
If yes I use a 6 point socket or a line wrench.
Yep:
A long sheet metal screw, in the center, then pry it up, out.
A long sheet metal screw, in the center, then pry it up, out.
Last edited:
TrailBeast
AKA Mopars4us on Youtube
Ah, the seat itself ok. 
kittypancake
Well-Known Member
Is there a way to do it without destroying the seats?
Doubt it that's why they come in good rebuild kits
Nope, not in my experience.
Those are sacraficial parts, if you have to take them out.
And don't ask where you can get, purchase, new seats.
I don't know.
I tried finding some of those for a Ford, Kelsey Hayes, 4 piston caliper that i rebuilt, needing seats.
Couldn't find any.
I guess they are only available at the manufacturers level, or the formal rebuilders, out there in the USA.
Certainly not available at the parts store level, as they were never ment to be replaced.
Let me know if you have any sucess in finding them, if you go that route and research it.
I just sent a mopar rebuild kit to Sweeden and they were in it. Never saw them individually. Wonder if a pin vice would pull them.
-
