roosduster
Colorado Mopar
How do you install a transmission governor into a 727 transmission? Are there any special tools needed? Also where exactly is it in the transmission? I was told towards the tail shaft.Thanks
Transmission Governor
- Thread starter roosduster
- Start date
-
bobscuda67
Well-Known Member
Nothing special, maybe a pair of snapring pliers. Just take off the tail housing.
You can even do it still in the car.
You can even do it still in the car.
roosduster
Colorado Mopar
Thanks, is it pretty straight forward once you get the tail housing off?
fishy68
Tyr Fryr's Inc.
Yes it's easy once you get the tail housing off. But you'll need a set of large expanding groove ring pliers (think that's the name?) to get the tail shaft off and a large snap ring pliers to get the rear support bearing off. Then you just need a small screwdriver to pop off the c-clip holding in the pin that goes through the governor weights.
-
