Trim rings for deep dish mopar rally wheels info needed

[flathead31coupe]

Does anyone know what trim ring fits this will I believe it's a 14 inch deep dish rally.
Thanks

 

[BrianT]

Mine are 15X8 but I believe these to be standard 15" trim rings

 

[flathead31coupe]

OK ty

 

[flathead31coupe]

I noticed at least by looking at your rear trim. Rings , they look a lot wider than the ones on the front period i'm trying to figure out which ones I need are how wide the ones on the rear are

 

[flathead31coupe]

Does anyone know what trim ring fits this will I believe it's a 14 inch deep dish rally.
Thanks

View attachment 1716203426

There is about 1 1/2 step from the edge of the rim down to a small lip then down to the center...will the trim ring just go the 1 1/2. Or all the way to the center passing the small lip

 

[flathead31coupe]

Here is another pic of my rear wheel... Does this take just a standard trim ring like inch and a half , or is it a wider trim ring thanks.

 

[flathead31coupe]

Here is another pic of my rear wheel... Does this take just a standard trim ring like inch and a half , or is it a wider trim ring thanks.

View attachment 1716207248

Does this take a stock trim ring or a three inch deep trim ring or what thanks

 

[BrianT]

I noticed at least by looking at your rear trim. Rings , they look a lot wider than the ones on the front period i'm trying to figure out which ones I need are how wide the ones on the rear are

Sorry, I just now noticed this. The rings on the back ARE wider, but that is because they are 15" wheels and the fronts are 14". 2 3/4" wide on the back and 2 1/2 on the front. Hope this helps.

 

[flathead31coupe]

Sorry, I just now noticed this. The rings on the back ARE wider, but that is because they are 15" wheels and the fronts are 14". 2 3/4" wide on the back and 2 1/2 on the front. Hope this helps.

Thanks