U-joint question

[CarfinaticII]

What is the u-joint I need to get these two yokes together? 7260? The one in the driveshaft looks like a conversion joint. It needs replaced but looks too big for the slip yoke. The other is the slip yoke out of my a904.

View attachment 1715437864

 

[Dana67Dart]

What is the inside measurement of all the yokes.

 

[CarfinaticII]

What is the inside measurement of all the yokes.

2 1/8

 

[Dana67Dart]

Then it look like you don't need any special u joints, all have the same dia?

 

[CarfinaticII]

Then it look like you don't need any special u joints, all have the same dia?

Yes, both are 2 1/8 inside. The outside of the slip yoke is 3 1/8 and the outside of the drive shaft yoke is 2 7/8. Maybe the outside doesn’t matter. So both are 7260 yokes?

Would a moog 246 u-joint work?

 

[Dana67Dart]

Looks like 7260 all around. Assuming cup od is about 1"+

U-Joint series identification

 

[CarfinaticII]

Looks like 7260 all around. Assuming cup od is about 1"+

U-Joint series identification

Thanks! That’s a handy chart to have around! Great info

 

[Dana67Dart]

Mopar of the time use an inside snap ring to locate the cups so an inside dimension is of intrest. Ford's of the time use an outside snap ring so overall width is of interest.