Want to check out my new Kevko pan?

[Benjamin Franklin]

Its the M202. Went on like a dream It was just me and i didn't flip the engine over. Used a feel pro 4 piece to seal it up.

 

[SpareParts]

I hope you spent about two hours cleaning weld spatter out of it!
Speaking from 4 pans of kevko experience

 

[fratzog lover]

How was it getting the spatter out? Did you media blast?

 

[SpareParts]

How was it getting the spatter out? Did you media blast?

I used a wire wheel, a screw driver/chisel and a hammer along with miscellaneous items that knocked crap out

 

[fratzog lover]

Kinda looks like there are fewer and fewer auto parts manufacturers who care about quality. Metal shavings in anything machined is a pet peeve.

 

[1970Duster]

I didn't have any of those problems with my milodon road race oil pan.

 

[FJ5]

I didn't have any spatter or trash in my kevco pan.

 

[SpareParts]

Well then call me stupid lol. All 4 of the pans I had starting back in 09 had crap in them. One of them I could tap with a hammer a few times then hear little BB's rolling around! My opinion is great bang for the buck but pay attention to the little things, new pan is custom fab'd anyway

 

[SpareParts]

I didn't have any of those problems with my milodon road race oil pan.

The last Milodon I had was clean but a lot closer to the K frame

 

[abdywgn]

nice looking pan! is that the Kevko p/u for the pan? Bob

 

[Bakerlite]

Well then call me stupid lol. All 4 of the pans I had starting back in 09 had crap in them. One of them I could tap with a hammer a few times then hear little BB's rolling around! My opinion is great bang for the buck but pay attention to the little things, new pan is custom fab'd anyway

Those BB's are just the right size to get through the holes in the pickup and into your pump.
You should always check and de-frag any new custom sumps.