[WANTED] Water pump pulley

-
Status
Not open for further replies.
I have 2 of the 3 pictured

91A300A6-58FA-43E4-A088-DCB4A09E31D4.jpeg


76E07936-53BF-479F-BDBF-C96F2BCE269C.jpeg
 
Thanks but the depth if the pulley is more than 2 5/8". Your ruler has a little extra on the end before the first line of measurement. I usually measure the pulleys with a tape measure down through the center hole to the table.
 
See if these will work, I can send better pics later today. Early cast pump on the left. Last pic is alum pump pulley.

20220823_065244.jpg


20220823_065051.jpg


20220823_065201.jpg


20220823_065222.jpg
 
I got the 2 5/8'' pulley , but its 6 15/16 diameter...

That's what I have now. The 6 15/16" dia. puts it too close to the crank pulley rear groove so much so that I can't put the belt on it without removing the fan and pulley first. Mine is also 2 11/16" deep and doesn't line up with the rear groove of the crank pulley unless I put a spacer behind it.
 
That's what I have now. The 6 15/16" dia. puts it too close to the crank pulley rear groove so much so that I can't put the belt on it without removing the fan and pulley first. Mine is also 2 11/16" deep and doesn't line up with the rear groove of the crank pulley unless I put a spacer behind it.
mine is 2 5/8'' inch deep ...
I ran it with a stock hemi lower pulley for a couple yrs.
 
Status
Not open for further replies.
-
Back
Top