Will bellousing 3893728 work

[dodge71demon]

OK for all of you out there that know a hell a lot more than I do on this matter I just purchased a complete bellhousing # 3893728 will it work on an a body?I know it's for a truck.Besides timing hole what's the difference between that and the 3743859 housing.And yes I know it will take the 11" flywheel and I do have the OD tranny

Thanks on any help

 

[dodge71demon]

FYI from Wayne at Brewers

I would not recommend trying to use in a car, pattern is for NP435 trans, and uses 11" flywheel.

 

[RustyRatRod]

I'm guessin this is a V8 bellhousin?

 

[dodge71demon]

I'm guessin this is a V8 bellhousin?

Yes small block

 

[RustyRatRod]

Ok. Was gonna say if it was a slant I might couldda helped you out. I have several and none were right for me until Ed (805MoparKid) was nice enough to send me the right one. I was gonna pass one of my other ones on to you, but all of mine are for slants. Sorry.

 

[thomasjkt]

make sure your tranny bolts up to the bell housing, I was going to use a truck bell housing but found it wouldn't bolt to my tranny. Wasted all that money on having a flywheel machined only to find I can't use the 11" setup. Anyone have a balanced flywheel for 10.5{" Clutch