SRT_DSTRHOLC
Well-Known Member
Does anyone sell one or just custom make one?
Windshield Wiper Delete Plate
- Thread starter SRT_DSTRHOLC
- Start date
-
LIME TWIST DART
Well-Known Member
Also interested to know.
When I built my race car, I just made an aluminum plate patterned on the piece that goes through the cowl from the bottom and made a gasket from bulk gasket material. Then I used stainless steel plugs to close the outside cowl holes.
Hmm....got me thinking.
partsman1965
Well-Known Member
I was going to use some 1/4 aluminum plate I have laying around for a/c and heater/blower openings. Use openings for template and polish it up and use stainless torx bolts to mount.
MidTexCuda
Ancient Member
We had some plastic caps that came off an AN fitting that fit in the holes perfect, were paintable, and removable.
I think hes talking about the wiper motor hole, I would just make a plate but if someones making them I would definitely jump on it.
SRT_DSTRHOLC
Well-Known Member
Ya where the wholw motor goes not the ac plugs
LIME TWIST DART
Well-Known Member
Ever find someone making deletes for this?
SRT_DSTRHOLC
Well-Known Member
nope. Think I might just get some thick aluminum and cut to fit
torkflight
Well-Known Member
I just made mine out of a piece of 18 gauge stainless, it has a sort of diamond pattern on it. took a couple minutes.
SRT_DSTRHOLC
Well-Known Member
That's what I am going to do!
LIME TWIST DART
Well-Known Member
Great place to mount my coil feed thru. 2 birds, 1 stone. Hadn't crossed my mind before.
SRT_DSTRHOLC
Well-Known Member
Maybe I will do that too, but requires two wires -_-.. So might just keep coil in bay and mount on the delete plate
-
