Need some help with my Duster 360 restomod. Ran fine for over 4 years and one day just wouldn’t start. Turns over but no spark. Replaced coil, distributor cap, rotor, distributor pickup. Still no spark. The shop that did the resto did a terrible job with wiring. However, car ran fine until end of last season. I’m thinking ecu might be bad. Car has a 1995 5.9 360 power train. Any help is greatly appreciated.
Won’t start
- Thread starter app1nag
- Start date
-
ECU lose it's ground ?? Or just bad.....
abdywgn
dismantler
Ballast resistor?
thanks for reply...how would I check that?
Thanks for reply..I don’t think I have one.
I better clarify... are you running the 5.9 EFI ?
Yes
It’s stock 95 power train from Dodge Ram. EFI.
ok, I've not been involved with that swap, sorry and good luck
Hellrats
Just another dumbass
Check to see if you have a signal from the crank sensor. It has to see crank and cam sensors to have spark. The cam sensor is in the distributor. Also called the pick up plate. You should be able to scan it and get a code.
-
