https://www.pehub.com/2015/01/z-capital-backed-msdp-acquires-accel-performance-group/
If nothing else I hope this improves the absolutely dismal support structure Accel has right now.
<edit, my bad, meant for this to go in general forum, sorry>
http://www.costco.com/.product.100121916.html?cm_sp=RichRelevance-_-itempageVerticalRight-_-CategorySiloedViewCP&cm_vc=itempageVerticalRight|CategorySiloedViewCP
Looks a lot spec wise like a Honda or Yammy, I've got Costco gift card that could pay for half and I could use a gen.
ANd the hits just keep on coming :( Got the accusump pulled and bypassed. Fixed a small cooling issue (one fan not coming on and bad cap), even had time to put exhaust cutouts in since it was up on lift. LJASD@!!*(*!! alternator crapped out 7 miles from home. Made it on 11 volts to the house...
This could have been SO much worse. On beer 4 right now thankful it didn;t burn...
http://www.forabodiesonly.com/mopar/showpost.php?p=1970604740&postcount=103
OK, W T F!
Went out to check the coolant level etc. and the most impossible thing had happened. The car as an oil accumulator on it for reserve pressure. Sitting parked, off and cooling down the entire bottom of the accumulator blew off. Tossed 3 quarts of oil under pressure all over the...
Thanks for the comments! Just put in in the driveway, need to see if both fans are actually working and make sure there wasn't a pocket of air somewhere in the cooling system. Last 4 miles of a 37 mile run from the shop it ran up to 210 degrees. Letting it cool down to check fluid levels...
Awesome, thanks. Gotta love the naming inconsistencies. Found a piece of the old stuff to measure and off to shopping i go. Wonder if I could find it locally at an upholstery shop...hrmm, sounds like a task for Friday afternoon
So close...:) This weekend is the big drive it and find things trip, probably 200 miles over three days combining rural and interstate.
The quest for parts is now getting real fun when dealing with a less than popular model :( http://www.forabodiesonly.com/mopar/showthread.php?t=293242
OK, so I think that's what it's called after digging thru a scanned parts catalog for an hour. The trim that goes on the pinch weld at the back of the door opening between the rear interior quarter at the edge of the window down to the sill plate.
Mine was beige and trashed and long gone...
1st drive....learned a few things:
1st and formost make sure the damn gas gauge is actually freakin accurate. Talk about a bummer :( Thankfully I was able to not sit and wait on the side of the road, rolled into a huge entrance to a subdivision and called for gas.
Once that bit of...