This could be a good discussion. I know @pittsburghracer has built a couple.Here is another diy solution with documentation.
Note, the pages in the PDF files are of order.
This could be a good discussion. I know @pittsburghracer has built a couple.
This could be a good discussion. I know @pittsburghracer has built a couple.
That's awesome, thanks for sharing the pics. Looks finished to me. How often do you use all 8 motors? How many are typically used?Then I bought a 400cfm commercial bench with two liquid manometers. I hated it. Big blower motor and the liquid manometers were affected by weather hourly. Not repeatable enough for the testing I wanted to do. I went head first reading and learning everything I could about flowbenchs and decided to go with Bruce’s PTS bench. A buddy of mine cut all the wood for me in his shop for a couple cases of beer (he wanted nothing). Built it, wired it, and I know if I’m not over 1000 flow tests I’m close. Heck I’ve done 8 in a single day. To this day I never finished it as it should be final painted and the front doors installed. I can flow a head today and in August I doubt if it would vary 2 cfm because it’s an “orfice” bench not a “pilot” bench. Calibration is checked everytime I change the head mount but it never changes. I have the calibration plates so I check it. It’s an 8 motor bench that can test up to 36 inches and I’ll use that if I have a problem I can’t find. I can test up to a 525-540cfm head. I make my own head mounts out of 1/2 lexan and cylinder sleeves. I then drill them for bench mount holes and use a head gasket to lay out the bolt pattern.
View attachment 1716061788
View attachment 1716061789
View attachment 1716061790
View attachment 1716061791
View attachment 1716061792
View attachment 1716061793
View attachment 1716061794
View attachment 1716061795
View attachment 1716061796
That's awesome, thanks for sharing the pics. Looks finished to me. How often do you use all 8 motors? How many are typically used?
I should add to that on my digital manometer has a place to hook up rubber lines to hook up probes to Check intake (J hook) and exhaust (straight) probes too. Checking airspeed has taught me more than anything and I couldn’t do it till I built this bench. I bought two extra probes as I have a handheld digital manometer and I’m going to see if I can calibrate it so the friend that bought my bench could further his education. I also bought an automatic depression control that when I changed my lift it would automatically go to 28 inches. I bought it probably six years ago and never wired it in. Probably never will. Bruce offered to buy it back from me. Lol. He’s working on a nice panel now and is going to make me one. For the Facebook guys he on there.
View attachment 1716061803
View attachment 1716061804
Been a bit so I thought I'd bump this up a bit.
What vacuum motors did you use when you built yours? I'm seeing some up on ebay for really cheap that claim new Ametek, single stage, 120,5CFM, 240v at 5.5A. I can get 6 for less then $180.
Is 2 stage important? What other factors need to be considered?
EDIT: Found my plans and the 2 stage 115923 is explicitly called out so single stage is out. That said, these can be found for less than $70 each which isn't bad.
It’s been so long that I honestly can’t say but in the 50.00 blueprints and instructions Bruce recommended the company and which motors to buy. I recommend joining his website and learning everything you can.
Yeah I forgot they were listed in the plans but the motors in the link are different now (things change over time). But, as mentioned in my edit above, that just means the older ones are cheaper now.