Praying for ya.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Unconventional
Well-Known Member
Put ya on the scope. Mess with the advance curve some. Check the AFR. Back in the race.
Inner fenders secured, hood latch on drinkers side is wonky, was going to adjust it, but i will pretend its just fine. Have to remember to snug up a couple hood bolts. I may wait, as i think im pulling rad out next. Hood may have to come off for that.
Unconventional
Well-Known Member
Good time to make those wood inlays for the console and such 
So........ your saying she's the boss?
Ben Drinkin
Hey bartender!
Darwin award winner
Plan on it.
Amature strategically placed Tannerite bags, guns an beer what can go wrong?
Had to do a quick run the roads are allready a mess around here and it just went below freezing. This will suck.
Score!
Nice kit!
They have been poping up cheap lately. Have two now done.
I can put it on my "Meters by Tim" Table.....
No worries. He'll get them back with his valve covers. I'm not a pirate. Arghhhhhhh
Sure you are!No worries. He'll get them back with his valve covers. I'm not a pirate. Arghhhhhhh
Knocked one whamo out of running board, going to bolt it on just like that.
One crack welded and a stiffening plate plug welded back on.
One crack welded and a stiffening plate plug welded back on.
Oh good God, if I had a rack like that I couldn't reach the blast cabinet. Lol
I do like the outfit though.
You know me too well Mike.
I do like the outfit though.
You know me too well Mike.
Forgot. A photo. These things are big!
Oh good God, if I had a rack like that I couldn't reach the blast cabinet. Lol
I do like the outfit though.
You know me too well Mike.
Ben Drinkin
Hey bartender!
Rack? I like racks!Oh good God, if I had a rack like that I couldn't reach the blast cabinet. Lol
I do like the outfit though.
You know me too well Mike.
I need to sell more parts I just used up the last few $$'s of my Pay Pal account balance.
-
