Recent content by 03ramit1

These would be cool cut on a Cnc plasma. You could have the word "Hemi" cut into them in the correct font. If only there was a guy willing to cut them for ya. (I could do it ;) )

What no one finger salute? I feel cheated.......LOL

Anyone have issues getting the Hemi installed using TTI motor mounts for the early k frame (biscuit mounts) we spent way too long trying to drop the motor home, spent way too long trying to get the TTI headers to fit, the headers fit great until we tried to reinstall the torsion bar on the...

Faster shifts, and easier in traffic since your not constantly running a clutch.

X2 that's what we are doing. Easy and makes for a fun driving experience.......

It will be remote mounted. The motor has the TTI block off plate on it. And we will come out the side of the block through the test ports just above the factory oil filter location.

Just wait soon that Hemi will have a Trans behind it. And will be ready to fire up...... I can't wait to drop the hammer and light up the tires...... We really gotta do a bunch of custom stuff. I wanna use it as a NBDF show piece.

I can't wait to see this running. It's going to be a lot of work but we will get it going. You need to get that PCM shipped off and get it back so the wireing can begin........

I'm not sure on the bore and stroke, but it's very mild on the bore. And the displacement is from the stroke. As we wanted maximum cyl wall thickness. And the stroke was added because if your replacing the crank you might as well grab a few more cubes. The motor was built with large boost...

Any boost is pushing it in the stock pistons. You can run 6-8 psi but who wants to stop at 6-8psi? Build the motor now, for your ultimate goal later. You may sacrifice a bit of power now, but will greatly make up for it later.

You guys know he never said rear wheel or flywheel. And 500 to the wheels is possible. Not cheap but possible. And I hate to say it but comparing the new cars, with what an a body will do are drasticly different. The modern transmissions soak up a ton of power. The 03-08 Hemi (345hp rated in the...

Yeah the, 545 trans runs at 28% driveline loss. What is a 727 for driveline losses? About 12% or so I think. But o may be wrong.

His engine is a 09 5.7 stroked out to a 6.1 all forged internals, running a magnison blower, with the smallest pulley pushing 11psi. The motor was built with the blower in mind, and pushed his 09 crew cab ram to a 12.2 in the 1/4. The truck is aprox 5800 pounds. Should make for a monster in the...

Hey chris. Glad to see you made it here. I can't wait to tear into that car. You gotta bring it by on saterday. I need motivation for my duster.

The tool you asked about can be found here https://millerspecialtools.spx.com/Detail.aspx?id=766 It's not needed as I have done many many pushrods without it, but it's a nightmare your first time. It's used to hold the intake pushrods in place to align them for installing the rocker shaft. When...