Recent content by 340dart.812

Hello I have a 71 dart currently running a 360 with ld340 intake and dual scoop swinger hood. I am looking for a hood that will clear my new motor with w2 heads and Indy high rise single plane intake. Only thing I know of is the fiberglass 6 pack hoods. So I guess that is what I am looking...

currently the coil on the fender is hooked up. the msd blaster ziptied to the firewall was trying to find the problem. Thanks rick maybe my gap is too large. I will reset the gap to .008 and try again.

Hello I have a 70 dart with a built up 360 in it, and have ran into a wierd ignition problem. I cant get it to throw any spark with the dist in the car and cranking it with the starter. but if i remove the dist and simply turn it it will spark correctly. when i turn it by hand it seems like i...

What you are feeling is the rearend twisting down and the leafs bouncing it back up, over and over again. Anything that can cause the drivetrain to start bouncing. Its most likely the first two but here are some other causes 1.incorrect pinion angle-adjust pinion angle with shims to 4...

Rightclick- Set as desktop backround-Leftclick stretch-leftclick set desktop backround for windows xp

How does moisture stay in the wrap when the header is between 450 to 900 degrees??? IMO the extra heat that is not able to be released through the surface area of the header which raises the heat of the tubing greatly is what causes damage to the header. The purpose of header wrap is to...

that cam should work good. Got any pics of your duster???

Good info here^^^^^ My combo with the 107s and stock heads was pinging with a holley 670 street avenger. I have an air fuel meter and it was lean in the mid rpms even when jetted too fat on top and it was pinging on 94 octane with only 28 total timing and I couldnt bring the timing in until...

Cam http://www.summitracing.com/parts/CRN-693801/ Pistons http://www.summitracing.com/parts/UEM-KB107-030/

Here is my budget 360 build I used KB 107 pistons with the baddest street cam ever made.....LOL seriously I ******* love this cam crane powermax will work great with stock stamped rockers. Seriously the baddest street cam ever made Sounds a lil rougher than a stock 340 cam. I have 19 in of...

great info /6 dan!!!!!!

Wow nice work.....Is that stripper avail for over the counter purchase or do you have to be special to get some??? Thanks Dillon

Damn those Flexplates for them furds are super hard to find.......give this a look it maybe the only one in existance...lol...

Looking good John. Do not weld without a helmet. Yes you can get burned on any skin that is exposed. I have burned my eyes with them closed before. Doing a small maybe 10 minute repair without a helmet with my eyes closed. About an hour or two later my eyes started burning real bad and I...

Here is what I found after a little grinder time..... I am a little sick