Recent content by 68 Notch Back

Quick update.....I installed a deep transmission pan (+2 qts) and an extended fluid pickup and it shifts great on every pull. Lesson learned.

I was reading on the Hoosier web site, that you should inflate the tire not to exceed 40 lbs to seat the tire to the rims, then adjust the air pressure as needed. I inflated mine to 40# and let them sit for almost a week. I took it to the track last night and let the air out to 18# they did...

Went back to the track last night, with good results. After the first full pull that resulted in the trans NOT shifting into second, I went back to the pit and checked the trans fluid. It measured a little low on fluid. I added about 1/2 qt or Type F and took it back out. It ran good with...

I am manually shifting, and it was built by a place called Shifters in Jacksonville Florida. I will pull the dipstick this morning.

On a new set of Hoosier slicks with 16 PSI in each. I stuck a piece of tape on the tires aligned with the valve stems so I could tell if the wheel was turning in the tire. To my surprise, one side had turned about a quarter turn and the other side about a half turn. Is this normal? How much...

First run at the track was a normal run. Then, with a normal launch, when I shifted to second, it did not change. I got out of it and shifted again and it went to 3rd. Three runs with the same results. I have a B&M ratchet shifter and a Turbo action Cheeta XtremeAction manual valve body. Just...

Are you saying that the Mopar Perfotmance stuff is bad? I just wanted to know if maybe one set was wider/longer or what.

I understand that the 665AB is the A body but the pictures look the same. Except for about $50, what is the difference in the two?

What a crock of SH1T!!!!!! This man's ignorance of how Pay Pal works is amazing. This BS about him telling me it cost extra for a PP invoice is just a bald face LIE! If this were the case, you would simply add the price of the invoice to the bill, not make me pay the $12 cash after I had...

Thanks for the information and pictures. Here is what I ended up doing. Not as nice as some of your, but it will do for now.

Fishmen67- do you have any pictures? Did you run the cables under the car andbehind the bumper?

I was going to wait on mentioning the company, but, Dynamic Renovations was the place that I ordered from. Having said that, I really hope that there is some kind of miscommunication.

I just sent ANOTHER email and will wait until Tuesday (to give them a full business day) to reply. Hopefully, there is some misunderstanding and we can get it straightened out. At any rate, I will post an update on what (if anything) I find out on Tuesday.

Thanks for the link. I searched for shackle bracket mounts and get about 30 pages of stuff.

Searched FABO with no luck, So I will ask the question here. Where can I find the rear shackle hanger bracket for me 68 Barracuda. I ordered a pair online but I am not sure they actually had a set to sell and now they will not answer my emails. I will withhold the name of the company for now...