Recent content by bmoparmofo

Hi, no I did not run a separate ground. Everything else is working properly just the turn signal indicators are inop on both sides. Completely baffled it seems pretty uncommon that both circuit boards would be defective. Both harness are showing let the power from the turn signals are making it...

Well as an update I'm getting power for the turn signal indicators on the harness at the dash cluster. The left signal comes from the three pin the right signal comes from the 8 pin Yet neither one is working on the cluster. I tried switching bulbs and switching the black plastic holders. Still...

Thanks I appreciate it!

Does anyone know what color the wire would be coming out of the column that I should check? I tried looking to find the 3 pin connector on an online schematic but I actually don't see it. I know what should be the top wire on the three pin at the cluster. Trying to do it without pulling the...

I should just be able to ground a test light and then probe the top wire on that three wire plug on the back of the cluster? In theory that should be the wire that sends power to the indicators on The cluster? I certainly hope the new circuit board is not defective...

Thanks I'll check it out it just seemed weird that they were working both the front and back outside of the car... just not working on the indicators on the cluster.. I know the 3-pin is plugged in correctly on the circuit board.. I'll have to look around for the wires coming out of the column I...

Hi working on the 67 Barracuda. Just installed a new wiring harnesses and new circuit boards on the cluster and all new bulbs. Everything seems to be working with the exception of the turn signal indicators inside the car the turn signals are working correctly outside the vehicle just no...

I believe it is. I'll try to get an inspection mirror behind it tomorrow maybe. I replace the circuit boards when I was out as the old one had loose pins. It's also a new wiring harness. But boy it's just seems like it's way more effort to even get it as far as it is than it should be. It...

Hi trying to reinstall the dash on a 67 Barracuda. Just wondering if this gray plastic round connector is supposed to seat all the way to the circuit board? Or if this is as far as it's supposed to go? Don't want to keep pushing on it and start breaking pins off or something.

That makes sense, thanks for the info!

Thanks very much for the help... I appreciate it everyone!

Okay thanks you reply so it's just kind of optional at this point? I'm not the one that disconnected it so it always adds to the challenge of figuring it back out.. thanks again

Okay I don't see any kind of a wire for it? A quick look at the diagram if I'm reading it correctly I don't even see it on here?