I believe the switch mounts under the dash, it was similar to the map lamp on the passenger side below the glove box for the 65 SS. I will look for my service manual to see if I have an image.
I took off the cover, it is the same there is a single indicator for the turn signal in the center of the instrument cluster. There are two pins for both boards. I am confident that the turn signal will not be an issue. I was thinking I can ohm out the leads from the connector plug and trace...
So will this make a difference is the only thing I would need to know. Will it cause me any problems if I were to just swap the pins for all the other components. I have a feeling the system will still function properly just by pinning out the system to match up the pins with relationship to the...
My 65 barracuda instrument cluster needs help. I purchased a 64 Cluster part number 2427427 and it had 9 pins on the connection to the board. Mine is 2496508 and it has 8 pins. I ohm'd out the 8 pin board as reference and see there are a few pins that must be swapped. But thinking about this I...
Gears are based on the transmission side, do you know what size Transmission the cable was removed from. Also I have a 65 and there are two different speedo's that can be in the dash, 80 mph or 120 MPH, so identify both ends may help.
Along the lines of our present discussion, Most of my clips for my 65 barracuda rocker molding trim are still on the car. How do I get the center plug out in order to remove the clips without damaging them. Any ideas, suggestions are greatly appreciated.