Recent content by C2ndLTpigeon

  1. C2ndLTpigeon

    [SOLD] 1973 6318 Thermoquad and Intake Manifold

    No, not at this time. Looking to sell not trade.
  2. C2ndLTpigeon

    [SOLD] 1973 6318 Thermoquad and Intake Manifold

    Bump Thermoquad $275 Shipped. Intake manifold $60 pick up only. Trying to scrape some pennies together to replace my AC in my daily. Thanks
  3. C2ndLTpigeon

    [SOLD] 1973 6318 Thermoquad and Intake Manifold

    Probably last call before I toss it. Bump
  4. C2ndLTpigeon

    [WANTED] Bucket Seat belts

    Just changed my seats in my 73 Valiant from a bench to a set of pro car buckets. My current belts are the retractable lap belt with attachable shoulder belt. Obviously the buckle part is too long since it was for a bench. looking for a set of front belts for buckets that I can replace them with...
  5. C2ndLTpigeon

    [SOLD] 1973 6318 Thermoquad and Intake Manifold

    Decided to sell my 6318 (1973 340 manual transmission) thermoquad I purchased in 2020. I originally paid $400 for it from a credited rebuilder who has an ebay store. This is not some Rockauto Reman, this one was rebuilt correctly. I originally wanted to run this on my 318 but after only 2 weeks...
  6. C2ndLTpigeon

    A different perspective on "THE BLACK GHOST" by UTG.

    In the end you people are listening to a washed up youtuber, that at one point used a mallet to hit in a camshaft in a fresh hemi block that the owner if the GTX had just spent a grip of money on at the machine shop. I thought his stuff was informative in the beginning but left after his bs and...
  7. C2ndLTpigeon

    [SOLD] 6318 Thermoquad clean rebuild

    Bump $350 shipped. I'm taking a loss but need it gone.
  8. C2ndLTpigeon

    Crane Rocker arm clearance on Iron heads issue

    Its the angle of the photos, I'm able to center them all on the head now after I ground the pedestals down. Just some fine tuning left to do with some shims.
  9. C2ndLTpigeon

    Crane Rocker arm clearance on Iron heads issue

    Couldn't of said it better. No point in cutting corners with all the time and money into this engine.
  10. C2ndLTpigeon

    Crane Rocker arm clearance on Iron heads issue

    Well I think I about solved the problem, and I learned something. Shaved some of the number 1 pedestal, Yes I know now that I didn't need to take it down that low. but it now clears the rocker. Also, like Kendog mentioned above I had to take the center pedestal in a little as well, it now...
Back
Top