Recent content by craigb

I need to upgrade from original rear transmission mount on 340 Dart. Balance weight on front of drive shaft is hitting bolt heads on drive shaft loop when launching. Summit has Energy Suspension brand for $49 and Bouchillon Performance sells theirs for $125. Any suggestions. 370 HP/ 380 torque...

Figured it out with help of Year One, changed from old style to newer style in June of 71. Our car was built in December of 70 so I got the older style.

There is a large tube in the trunk that is separate from fill pipe that I assume has something to do with vapor recovery or venting the tank.

I recently left my fuel cap at a gas station and need to replace it on my 71 Dart. Mega Parts lists non vented cap for 1971 and up and a vented cap for up to 71. How do I determine if I need vented or non vented cap for 71 A body?

Read the post by 67Dart273 on my "Under dash short post" it has a link to a good explanation of why you want to bypass ammeter. The car I am working on now has had the connection at the firewall burn off and a previous owner had the power to ignition switch burn off at steering column...

Should be 1 multi pin connector on each side. Red wire into ammeter, black wire out of ammeter. Bulb for brake system light on lower left corner. Fuel gauge should be included in one of the multi pin connectors. Three terminal voltage regulator to left of speedometer gets wire with 90 degree...

Tonight we were cruising down the highway at 60 MPH in our 71 Dart, engine shut down and before I could coast to a stop we had smoke coming from under dash. Got hauled home and discovered main power wire from starter relay to ammeter connection fried at fire wall. Ran wire through bulkhead...

Not sure what the voltage limiter is but has to be close judging by the length of the wire. The picture is of a spare instrument panel, I should be able to figure it out before I crawl back under the dash. Thanks

Anyone know if this capacitor? should be plugged in? It is located on the back side of 71 Dart instrument panel. It has a male terminal and is not plugged into anything. What is it's function?

Checked radiator number today, it's from 68 Charger. Who would have guessed!!!

I have a 71 Dart 340 with a 26" radiator. All the reproduction fan shrouds I find for 71 A body are for 22" radiator. Any body know if the Mopar Performance shroud for 26" radiator made for B&E body will work?

Ended up getting it to hold with just an o ring, thanks everybody.

I have my 71 Dart at a local shop for AC compressor replacement. They are having trouble getting the high pressure line fitting to seal on the discharge side of the compressor. The fiber gasket furnished with reman compressor didn't seal at all, they tried a metal gasket and got it down to a...

Thanks Bill. Looking at the pictures of the two different booster units it appears that the end of the rod that goes into the booster is different on the 71 and 75 units. anyone know if the linkage will be a direct fit? The 71 booster is smaller in diameter so I would prefer to use it if my...

I hope to upgrade 71 Dart to power brakes. I purchased a booster unit with bracket and linkage to use for a core and plan on using the bracket etc. The booster I bought is from a 75 Dart and when I look up boosters on Napa the 71 is and 75 Darts take different booster units. Anybody know if...