Thanks, but I'm not seeing the outer anchor nut or plate in either location on mine. I was concerned that the anchor may have been cut away and discarded when the tubs were installed. Possibly like Dana67Dart, although his is a ragtop. Ill take a pic and upload it.
Can someone please provide a picture of where the rear outer seat belt anchors belong on a 67 Dart GT. I am working with a car that was previously tubbed and am restoring it to mini-tub. Can't identify where the outer seat belt anchors should be.
Beautiful ride! I am attempting to assemble my 67GT (finally). I have installed a swap meet K member and a 440,727, and 8.75. I purchased it for $500 as an empty shell. Inner fenders cut out for fenderwells and quarters mutilated for slicks. I have been in the process of restoring the sheet...
I am trying to resurrect a 67 GT that I purchased as just a shell of a vehicle. I'm not sure how the vehicle was originally equipped because I have seen either a finish panel or what I think is a four piece upper and lower molding/trim set that "connects" the tailamps.
I need both sides roof to outer wheelhouse braces for a 1967 Dart GT. The previous owner hacked the braces out to install tubs. I am removing the tubs and restoring to the OEM configuration. I have attached an image of what the braces should look like, and an image of what's left of them in my...
charger426, I would like to know the vendor/manufacturer of the straps that you are using. I figured straps worked for OEM, as long as they are quality pieces I'm fine with them. I just don't want to trust my driveshaft to "cheap/low quality" straps.
mderoy340,
Are you saying that instead of drilling the yoke you just fitted the girdles with hardware store bolts, no nuts? I was thinking of that but didn't know if it had been tried and proven.