Recent content by dkamp

What is the size/Diameter ?

I had PRC custom make an aluminum radiator for me for $600 Look at their stuff. Performance Rod & Custom Boonville IN All tig welded, Great looking seams, Oil cooler in radiator, all very well done. Highly recommended.

I have been told that an Open plane (One big opening) gives higher Upper torque, and a 4 hole spacer gives better lower end torque. If I go with this 4 hole version Mr. Gasket 3406 Mr. Gasket Carburetor Spacers | Summit Racing (Mr Gasket 3406) I wonder if the Carb butterfly's will have enough...

Hey ! You are Da Man! and thanks for the Education and the link. DavidK

I have a 340 HiRise intake that has only the smaller bolt holes. I would like to add a 1 inch spacer (Wood or Phenolic, not aluminum) for heat soak issues, but cannot locate a spacer that uses the smaller bolt pattern. The carb is a 1406 Edelbrock with both size patterns. Any suggestions? Please...

Hey Guys, guess I can join your club now. I was really tired for a few weeks and Dr sent me for a Stress test I failed so then to cath to check blood flow. The widow maker was 99.5% clogged, the cardiologist introduced me to the cardiac surgeon and early the next morning when I woke up they...

Would there be any value for 4 of these to anyone?

I have 4 of this center piece but not sure what it goes to. Anyone recognize what they came from?

HVAC Service guys always told me, that as a furnace they turn into an Electric Heater when the Temperature gets around 35-38 degrees and lower. There just is no heat to pull from a cold day. so there is no heat pump activity occurring, just an old school expensive electric furnace.

Great answers. They stay. Thank you!

Since my garage is not heated and uninsulated, each year about this time I turn off the water, move all my waxes and paint cans to the basement. I was wondering if I really need to also move my wd-40 and other aerosol lubricants too. Do you? Should I?

what is unique or bad about "134a replacement"? is the replacement the 1234yf ?

I was careful to not get the can with additives, and they all say: Meets or exceeds AHRI 700-2006 and SAE J 2276 purity standards I wasn't sure if there was different chemical formulas that might not mix well with others. David

I was recently shopping for a 12 oz can of 134a and noticed that some places it is as low as $8, and others it is $22 a can. Is there a difference between the cheap and expensive 134a freon? if so what do I look for? David

Bushing Install Tool is still available with a price reduction. Interested?