Recent content by dusmon

Has any one tested hp on a stroker between the strip dominator the 340 victor and the super victor. I heard the 340 victor was more hp than the strip dominator any one got some results on this ?

I have unported SV on my 416 best of 10.18

In the bottom hand written picture you show 3 intakes the 1st one you have ported edelbrock what manifold is that?

You 3 intakes what is the ported edelbrock?

Put new fuel pump in. that helped. Only thing not checked is the tune. As I don't have a way to do that. 25 year old ignition. No dodge dealer has the tools anymore. I did get the injectors phased and that was good. Get 17mpg, runs nice.

So what you say is a 360 like 1999 has a different cam that advertised by most on the net. I have a stock 1999 360 mag 4x4 that I think is a little doggie runs nice but not enough towing torque. I believe I have the .432 lift cam in that motor. do you have or know of some specs for my truck...

I put a slapstick in my duster shifter out of a 78 Cordoba body style. So taller shifter rod. used 68 a-body z bar. Had to drill a hole in z bar to get proper ratio to work.

Do you have a picture of the inside of fender?

I just rebiult a 5.9 magnum same thing #4 cam bearing was bad.

How much lifter preload you setting them at?

same as in the 1980 direct conection manual just read it

I had a set of comectics and after I pulled the heads there was pits from the gasket in the aluiminum head. and mine leaked so 1008 it has been for 10 years. I'm not a fan of Cometics.

I just bolted a efi pro4 on a 416/340 block edelbrock heads. Yes I had to grind on the intake to get bolts to fit in #3 and #6 inside intake holes and slot all bolts to heads as the ports lined up but holes were 1/6 high for bolts to fit. And cut 2 bolts shorter. And if edelbrock would raise...

What are a pair of 15x3.5 small bolt Centerlines Worth?

plus 185lbs for driver