I am running a 360 with a 727. I went ahead and installed the 1 5/8" headers since i have them. I have my clearance for my steering figured out now! I installed the OEM starter, so i figure when i have to replace it i will install the mini starter. I had the motor pulled up to drill/tap/cap the...
Thanks everybody for all your input! I really do appreciate it! so it sounds like to me, is go with the mini starter and dump the 1 5/8" headers! I did buy the hooker performance headers 1 5/8" I will do some good research on headers before i buy again! Sounds like the super comps might be the...
Hey Guys, Had a question, i installed hooker headers on my 74 plymouth duster and noticing a couple small issues! 1st: does anybody make a small enough starter to fit in the opening underneath? the stock starter does not fit and i have to lift the motor and disconnect the header to have enough...
Hey guys, picked up front and rear sway bars with all hardware and i am lost on how it mounts! does anybody have this set-up they can send me pics of or instructions? I bought this set from a Mopar swap meet and now i am lost! I know there are two different types of sets for the duster 70-72...
By chance do you have the rear bumper piece that extends between the body and the bumper. made of plastic. Not sure if the 76 came with that or not, but need one for my 74.
Thanks
Looking for the hardware for the front bench seat, I need the latches that fold down the seat so someone can get into the back of the car. do you have these? and would you sell them?
Thanks
do you by chance have the locking hardware for the front bench seat. the clasp,springs etc to make the front seat release so a passenger can get into the back.
Thanks
Go to any parts store and borrow their Harmonic balancer installer tool! very easy to use. I got a loan a tool from autozone and installed my balancer. DO NOT USE YOUR BOLT TO DRIVE ON THE BALANCER WITH A IMPACT!