Recent content by ev2

Hey Rusty Thanks Math works For 42 43 second option if buddy first option is 43 he needs it more then me cool

need parts trade maybe

Cost

HELP:banghead:

can find the Echlin #VC-1810 advance can (about $10 at NAPA) or any can help

those are not the mag lifters. 2 turn preload

not hughes

Thanks as i bow out lol

Anyone used this lifters is the ? I have a answer,and if someone spam the problems that i had with these lifters ,2 people told 2 people those 2 told 2 more and so on i would have save thosands of dollars then those 2 people would save thosands and so on, what forum's are all about! Good and bad

More then you every know

3000 dollars plus time dam

Oil was not coming out lifter bore lifters would not pump up when running changing the preload change the sound of motor but did not go away first change oil pump ran MOTOR ON DYNO still had loud lifters change lifters fixed problem, much much less preload 1/4 turn lifters vs 2 turn...

Oil was not coming out lifter bore lifters would not pump up when running changing the preload change the sound of motor but did not go away first change oilpump ran still had loud lifters change lifters fixed problem, much much less preload 1/4 turn lifters vs 2 turn lifters preload

350 HUGHES LIFTER COST. THEN INSTALL & SET UP WITH MOTOR BUILD FIRST TIME RUN ON THE DYNO CAN HEAR PROBLEMS DYNO ROOM WAY TO LOUD WITH THE FANS AND SO FORTH PUT MOTOR IN SHOW CAR ,START ENGINE ,PROBLEMS ,PULL ENGINE TAKE BACK TO BUILDER,LOWER OIL PRESSURE TO LOW VOLUME PUMP VS HIGH,REPLACED...

416 524hp 537 tq