Recent content by Ferdinandbites

Sweet! Doesn't look much lower than mine.

interesting!

ok, 3' it is then.

that sounds good too

Ya, Ill be ok with any wear that would occur with the amount of driving that I do. Sht, let it wear and give me a reason to buy new wheels. Hmm, this is staring to sound better and better.

thanks, alright, I get it. the lower hole would be close to stock, the upper what would lower the diff. doesn't seem like it could lower it that much, what, an inch or two? I was thinking closer to 4. that also looks like something from the inside of vehicle would have to be re/re for the studs...

Not too sure what u r talking about. Looked at some pictures and it looks like that would raise the height? Maybe a link to a picture would help me to understand how this works.

Any suggestions on where to find some?

oh, its out for sure. It goes for short runs to the ice cream store(for kids) beer store(for big boys) and back around the corner.

ok, got it, thank you. Not a daily ride and I take care over bumps because its MINT, lol, I crack myself up.

factory

thank you seems to be the what most agree on right now.

I still have some spring to the front end. I have yet to bottom out. It does have some rubber stops where the lower arm meets the frame too.

Ouuuuuu, genius, that's exactly the amount of work I want to do for this and I could always change it back if I don't like it and easier. fantastic, vitamindart thank you!

In the rear spring?