Recent content by fishmarket

1045 Billet Steel Flywheel - New-440 Source

I bought a bunch of aluminum, hexagon tie rod blanks from Speedway Motors, on clearance on Ebay, a few years ago. I think they were made by AFCO. They were gold anodized. Ended up getting the taps on ebay and bought a handful of lock nuts from Speedway as well. EDIT In hind sight, they weren't...

I have a strip dominator as well that I was contemplating using. Wondering if they have as much potential as some of the other single planes?

Sorry, I was referencing when you upgrade to 2.055 and 2.080 valves.

Could you please share the part numbers for the valves you are using? Thanks

Had the same issue, pulled the threads out of a marette, drilled a hole through it slightly smaller than the hose ID and shoved it in just before the PVC valve. No more whistle... You may have to experiment with hole size.

eagles 52

Friday/Saturday? isn't it usually Saturday/Sunday?

Wheel Vintiques

15X8 WHEEL VINTIQUES WITH DOG DISHES. 235 60 15 FRONT AND 275 60 15 REAR

I had L4,L5,S1 fused at the age of 35. Its been 13 years, I traded one pain for another by having the surgery... I pretty much didn't have a choice though as my legs would go numb with radiating pain down the *** and legs. I have never been given anything for pain since I had the surgery. Makes...

What size is the roller on these? Tried to find it on summit's site but it doesn't have that info.

It's easier to simply grind a small groove inside the head bolt hole up to the oil hole with a burr, then you don't compromise the integrity of the stud as well. It literally takes 30 seconds to do.

I grind a small groove inside the bolt hole in the head to the oil hole with a carbide burr and a die grinder.

Rams 57