Recent content by Garrett Hurley

One is a parts store starter, and one is a cheap ebay one, but both same newer style starter with snouts. i didnt install the shim. Before installing the trans/motor i did check the tolerances as per the mopar manual said and nothing was out of whack, I used the correct crank hub bushing,and got...

Thank you guys for all your responses its been very helpful, as of now im grinding 3/16 off of one of the starters as a temporary fix,I know not ideal. but will definitely look into flipping the ring gear around, and paying closer attention to the tolerances when i drop the trans again. I just...

Ahh Makes sense, these are the 2 ive been using, im assuming thats the nipple youre talking about. What should i look for when buying a new one? Or maybe i can replace with different bendix gear?

Yes thats what I mean, thank you.

Between the pump hub and crank because the trans is 64 and motor is later 70s.

Installed a mini starter on my slant which had just had been rebuilt, early 904 trans and later 70s motor, used the correct spacer as well. Starter seemed to work fine until i kicked the motor over a few times, and it made a horrible grinding only at one spot. When i turned motor by hand it...

Thank you

Little out of my price range but thanks for the offer

I saw but I’m 3 hours behind the Florida guys kit sold before I woke up.

No luck at the pick your part in my area, figured there’s no harm in asking need 1973+ spindles for disc conversion or any corresponding parts. Located in So Cal willing to pay for shipping.

I have a completely rebuilt 225 slant 6 rotating assembly from the machine shop never ran (block cracked when I was transporting out of the shop I was in). Crank/rods/bearings/pistons .0.30 over. Crank is a 1964. Available for pickup in So Cal 90505 $200 OBO

Awesome thank you guys I was about to swap crankshafts from my old motor so glad I won’t have to rebuild My slant for the 3rd time. :p

Yes that’s exactly what I need just measured out w some verniers. I’ll send PM.

I recently bought a new block and turbo setup off Gilbert titan a member of this forum. My og block had cracked so I bought a new block and put it all together along with dutras Aussie Intake and ct26 turbo. I went to bolt my rebuilt 1964 A904 3 speed onto this newer block but the flex plate is...