Recent content by Gene Rea

I need one

The picture is the back of dash that I have behind fuel gauge.

I thought I had found the right Ivr and had it saved but must have deleted it. The ones I see now plug into the back of the dash near the fuel gauge but I have no where to plug it in.

I see the part, but I don’t have the slots that it goes into thanks. When Ilooked it up it is this

I have a 66 barracuda my fuel and temperature gauges are not working. I had found on this site a picture and part 5 volt resistor and can’t seem to find it again,now that I removed the dash panel. I don’t know what happened I had it saved and now can’t find it anywhere.

Checked resistor all good there.

Thanks going to look into that

Has anyone removed the a/c fan switch on a66 barracuda? My fan won’t operate from the switch but a 12 volt wire to the fan works. Trying to figure out if I have to remove dash or can I get to it just through the heater control.

How are you? Still never figured out my blower motor switch problem. Did you ever get yours working?

I think that’s the issue of the housings being grounded to the fenders. Would love to get them working.

I do have one other issu I haven’t figured out. The turn signal lights on the top of fenders I haven’t been able to get working. Changed the bulbs a while back and nothing doing? Im not an electrical guy but I think it is a grounding problem with them.

Thanks appreciate your input. I think I figured it out. The brake lights were on because the peddle had too much play in it so that’s why the lights were on and I’m pretty sure the horn relay was bad. Checked the wires and they are all good. I was frustrated and thinking the worst.

Please explain? What harnesses? All the wires are there, trying to figure out which color wires do what and see if I can just move them around in connector so they match up. Everything did work before just seems the two connectors have wires in different places in connector.

I was so hoping this was just going to plug in and everything would work.

I have a 66 barracuda and just changed from column shift to floor shift. I got a column from a valiant and installed it. When I plugged in the wire connector nothing works Horn,blinkers etc and when plugged in the tail lights are on when shouldn’t be. Trying to figure out if I can take apart...