Recent content by Ghostsoldier

Well, I feel like an *** now...it turns out, in my haste to get it fixed last night (and get out of the mid-20's weather, as I'm a true shade tree mechanic, with no garage space), I inadvertently forgot to plug the center firewall connector back into the block--I had pulled it to find the burnt...

I'll check the wiring again tomorrow....it's 25 degrees here tonight, and I'm inside where it's warm! :) Rob

Well, I went down and bought some 14ga. fusible link wire and some butt connectors, and hooked it back up, bypassing the block connection. I also disconnected the amp gauge and bolted and taped the two wires together to bypass it; the connections were a bit loose on the gauge, anyway. Now, I...

My fusible link in my '74 Duster fried yesterday, all the way up to the bulkhead harness plug. Since this left me with no excess to wire to connect into, I'm going to bypass the connector and install a fusible link in-line. My question is this: What gauge do I need, 14 or 16 amp? I can't find...

That being said, I decided to check a few more things this afternoon. Feeling like the slight hesitation that's left might be in the ignition, I checked my plug wires and plugs, just to be on the safe side (since the car has been in dormant storage for several months now). I found that all of...

I'm writing from work now, but I have to say that wiring the choke open like Johnny suggested has completely changed the way the car runs; it doesn't shut off at stop lights, and it ran a heckuva lot smoother this morning, on the way to work. Maybe it's my choke, after all. Rob

Cracked, I don't have a vac gauge, but I do have an induction timing light; my initial timing was set at 10-11 ATDC when I installed the new distributor last year. I'll try the distributor test in the next few days...I've got to drive it to work tomorrow, so I can't work on it tonight. Rob

Maybe so...but as I said, I have no way to check the rpm's...:) Rob

I'll try this Wednesday, Johnny; I'll be driving a different car tomorrow, because I have an appointment to keep, and don't need the aggravation of a malfunctioning car. Cracked...I don't have a tach, or any type of instrument to tell what the rpm's are.... Rob

I’m writing this from work, because I wanted to report the car’s behavior on the way here this morning (26 miles). Even though it did not shut off when put in gear, I noticed that after the car warmed up, and at one of my 6 traffic light stops, the engine still tends to miss...

73, I just got back in from trying your suggestions, and now the car seems to be running OK...when I drop it into gear, it doesn't shut off at all. Although the float gas levels seemed to be fine, I noticed that the float drop was seriously off...it's supposed to be 15/16" at the far end of...

Guys, I was going to monkey around with the jets and metering rods on my 600cfm Edelbrock 1406 (as I stated in another post that I started here), but before I do that, right now I have a new problem that's severely affecting the use of the car (for what it's worth, I have an electric pump and a...

^^^^^^^Nice stance! Rob

Thanks, pishta, I'll check it out this afternoon...I have two 727 trannies here at the shop (for my big-block project), and both still have the gear housings installed (like below)... BTW, I'm Delta One's dad (the original poster), and the chief mechanic on his Duster....I'm just now getting...