Are you running a stock block? What kind of tranny? Sorry for all the questions but I'm jus tying to figure out what my weakest link is, I'm doing a 414 solid roller motor with a single 80mm, we are shooting for 800-900 rwhp range and going through a race preped 999 trans and 8 3/4 rear.
70aarcuda if you go back and look at my original post I asked if anyone had a set of instructions not for Johns contact info, I already had that, he is kinda hard to get ahold of, I ment no disrespect in my post to you, I said thanks for your time, I don't think the last post was required. Thanks!
Looking for anyone that might a set of installation instructions for a jvx transbrake? Goin in a 904 or 999 trans. If I could get a copy of them it would be great! I have had the transbrake in a 727 for probably 20 years and would like to swap it into my 999 for my turbo 414 build. Thanks!
Hey guys, sorry it's been a while, you know how some of this stuff goes when you work and work but can't see much progress. I got the block sonic tested, short filled with hardblock then bored to 4.070, we preassembled the short block and clearanced everything then test fit the main girdle, jus...
Good body, 2x3 mandrel bent rear frame with 4 link, 8.75 rear, no center section, stock front end, make excellent pro street or race car, needs rear inside sheet metal and cage, have clear nc title, $3500 obo
Thanks guys! I will look into both lifters, I was just getting ready to assemble my motor and was told I had to tube the lifter oil passage, I was trying to find a local shop to do it but no one had the tools to do it. I have a set of used comp lifters I was gonna have comp rebuild and use but I...
Hi guys, I am looking to go with a solid roller also on my 414 turbo build, did u have to tube your lifter oil gally or is there a lifter that will work without tubing or sleeving? Thanks!