I am having a pretty hard time getting myself to actually sell my '65 Barracuda but that's life I guess. I think I expected I'd keep this car forever so no corners were cut in the restoration. I threw thousands of hours and even more dollars at it over the years. Rust was removed inside and...
I am re-listing a separate individual thread for my 1961 Dodge Lancer. I purchased her in 2018 on here from Doc Watson. Runs and drives. I have a detailed running record of every change/upgrade made by both Doc and I, plus a pile of spare parts including a windshield and bumper.
4-barrel...
Well, I guess even my mopars couldn't outrun the recession forever. Ive got a finished complete 1961 Dodge Lancer I purchased in 2018 on here from Doc Watson and an unfinished 1965 Barracuda that I had been doing a restomod project on until I ran out of money for it.
First 6 pictures are the...
I have no idea where to find these square rubber grommets that go around the bolts that attach the door hinges to the body of the car? Any advice on a source?
Any idea where to get those little square grommets that fit in the door hinges? I could probably make them, but would rather source them at the proper size if they are reasonable and available.
Thanks!
I think a picture would help quite a bit if it isn’t too much work. I am not entirely sure how to tell which side is would be driver/passenger? I mean, may even have them installed correctly, but they do not even remotely sit level on the floor.
Alright guys, I feel pretty dumb but I cannot figure out how these tracks should properly go. They are 66 dart seats going into my 65 barracuda. (To allow for a coffin console) Sadly, I do not even have the original holes in my replaced floor to match them up with.
Is there a drivers/passenger...