Recent content by Gtsjosh

If you’re interested in the car shoot me a message. Otherwise I’d rather not clog up a thread with nonsense.

Thank you. Just paranoid because my driveway is a very long steep hill lol.

Leaving the country for a while March 13. Come and get this perfect cruiser for summer. Selling my 69 gts. Has a new blueprint 408 with around 1000 miles. Matching four speed , 3.91 gears with sure trac from dr diff. Also comes with the matching 340 but the 340 needs gone through. Lots of...

Hi guys. I need to order a fan shroud for my champion radiator. Would anyone happen to know the radiator mounting hole spacing measurements for reproduction shroud 2998325 or have one they can measure ? Thanks.

I’ve got an edelbrock air gap new in box with bolt kit and gaskets , as well as a 650 avs2 carb that’s like two months old is well. my 340 started making metal and I think I’m going to go stroker.

Looks like I may be needing some engine work done soon. Anyone have any engine builders they recommend near sw Missouri ? Don’t mind driving a few hours. Thanks all.

Thanks everyone. I ordered a new cable from year one since nobody local had one. I’ll put this back together in a couple of days.

Anyone know why this clip / spring is for and how it is supposed to be installed ? My throttle cable broke today on my 69 dart and when it did this clip came off Off the gas pedal. I can’t seem to figure out how or where exactly it’s supposed to go where it seems to do anything ? Have a new...

Howard’s came back and also said this would be good for my car and that it would be like the popular purple cam. Crower recommended the cam below. Any thoughts on these ? Especially compared to the xe268. I like Howard’s and crower for US sourced materials over comp but keep coming back to the...

Yeah that’s what I was worried about. I’m out of the country until late June. Figured maybe if I order soon I could possibly have one to install this winter. Lol. Summits website actually says they have the comp cam ready to ship but not sure how accurate that is. Usually summit is pretty...

Looking at ordering a cam soon for my 69 dart gts with 340/ 4 speed. Engine is stock except for the usual bolt ons. Headers , dual exhaust , electronic ignition from fbo, avs2 650 carb, 391 gears. Tire are 245/60/15 next set I buy will be 255/60/15. Plan on doing the Edelbrock rpm dual plane...

Not yet. I’m actually leaving the country for work for about three months today. I spoke with doctor diff and I think I’m going to just order an entire third member while I’m gone with 3.91 from him and keep my 3.23 third member in the shop to swap in should ever take a long road trip with the...

I almost bought a wildfire , I ended up going advantage. They are pretty much identical but advantage had a distributor closer to me which made it a little cheaper. Both are great. I actually looked hard at tuxedo too and found that 2-3 of the off brands all seemed to be rebranded tuxedo lifts...

I’m also debating just ordering another thirdmember and keeping my 3.23. Either way what is better , the cone or clutch style sure grip or should I just do a truetrac ?

thank you. I’ve been playing around with some calculators online which is kind of what got me leaning to 3.73 and 3.91. Mostly looking for the best feeling 0-60 or maybe 0-80 times. Right now I’ve been downshifting a lot with the 3.23 and the 3.73 or 3.91 will do a better job keep Keeping me in...