Recent content by Hopp

I have this same setup in my 73 dart/360 with an Edelbrock carb. I can't seem to get to wide open position and then back to idle.

What are the best fitting manifolds for a 360 in a 73 Dart Swinger? Do you have any and how much would the cost be.

Thanks for the info. So unless I trim the opening I have to change the whole support out. I've noticed that this is not a bolt in as well so it will have to be spot welded. Maybe more than I want to do so a sawzall might be In order.

I am in the process of helping my son change his 73 dart from a slant six to a 360. He has purchased a 73 dart parts car that has all of the V-8 parts. It appears that the radiator support has a wider opening on the V-8 car than the one on the slant 6 car. Did dodge make two completely different...

Does anyone make a nice fully retractable seatbelt with the shoulder and lap belt all in one? I want something like the newer cars that will fit my 73 Dart.

So is what I'm hearing is that I can make my existing K member work for the new hemi with some fabricated brackets.

Ok new here but trying to figure out if I should find a stock small block K member or buy a new tubular one. I have a 73 /6 car and am converting to a Gen III hemi. I want to make sure I inly purchase the right stuff the first time so any help would be greatly appreciated.