Recent content by jay dcpt

Ok dave ill get to the shop this weekend and send you some pictures and if your still interested will go from there.

Pm me if interested i have over eleven grand in the drivetrain alone. Dealing with a trans problem now that will be fixed correctly. I honestly have close to twenty grand in this Car if not more.

I dont have to pry with a screwdriver it literally just flops back and forth not normal huh?

Ok thank you that is exactly the specs i have so i still have a problem. Tha nks everyone

Thanks for the replys fellas I appreciate all the input bu t with. The original post on the l r band and lever is thAt not suposed to have tension on it at all times? Or is what I described normal?

How bout a 73 340 duster not stock by any means but have reciepts to show what it has in it. Body is not as nice as that monte but I'm a big g body guy I have a few from montes to gn s. Just thought id throw it out there.

So I removed the pan on my 727 and found quite a bit of metal shavings on the pan. This is a rebuilt unit with 9000 miles on it. Now the lever for the low reverse band is loose am I mistaken but isn't there suposed to be tension on that lever? If I pull it down it just stays there. I was just...

The block didn't have to be decked whwn machine work was done I can post cam specs when I get home and ill post some picks of the plugs.

Thats why i was asking. The past references i was speaking in was setting timing and adjusting a carb on a sbc. However i am going to give this thing a tuneup this weekend and was wondering what plugs you guys would suggest using? The motor is a 340 bored 30 over srp pistons eagle rods 10 to 1...

what do you mean only on brand x?

well its a 750 cfm carb edelbrock. and from what ive been reading you hook up the advance on the left side of the carb. I was just wondering because on other motors i have messed with when you set base timing with advance disconected then hook it back up i usually see the timing change with the...

I have a 340 duster that's somewhat built big cam redone heads bored new pistons and rods. My question is I just took it out of storage and was going over a few things and I was checking base timing. I have it set at right around 14degrees btdc I noticed when I disconected my vacum advance the...

ok ill check that out. thank you sir.

So what did you end up doing to repair the problem? And thank you 66cuda for the website i have the same dillema in my 73.

Sorry havent had time to post pics yet. Redish, i dont think my car has a electrical problem and the only reason i say that is because i have owned and been driving this car for the past 12 years. I dont find it uncommon that a ignition switch could fail in that time, let alone how long it was...