Recent content by Jim Walsh

Bill: It appears that Chrysler offered the Saginaw pump on Small blocks that had the cast iron WP from 1967 to 1969. I will check out a local yard and let you know if I have any luck w/ brackets. It wasn't a common option in the day because only girls had PS. On the other hand, if you change...

Thanks, That's what I thought but didn't really want to believe it. Looks like an aluminum WP and radiator. Jim

Hi, I'm having the same problem. I bought a new Borgeson PS box and Saginaw pump from a junk yard 318. I also bought hoses and an expensive coupler for the combination. I need brackets. Did you find any that would fit the Saginaw to the 273 in my 64 dodge dart? Thanks, Jim Walsh

please mark no longer needed

It's been a while since I saw it, and it's hard to get to. If it came off an early A body V8, it should fit. How much do want for it with freight to Webster, NY 14580. Thanks, Jim Walsh

Wanted 64 dart V8 Z bar in good condition. Don't need ends, only main body. Jim Walsh

$100 is expensive seeing I only need the Z bar. How about $50 for he Z bar only? Jim Walsh

Hi: I just need the drivers side. I bought one before but the trim came to a peak on the top. The correct one is flat across the top. If that is the one you have, contact me at [email protected]. Thanks, Jim Walsh

I need the 9" trim piece that goes on the left rear corner (intersection) of the convertible top, top fender molding and side trim. It slides into the molding that comes across the fender top from the rear over the tail light. Thanks, Jim

Jake: I'm looking for a"Z" bar for my 64 dart 273 3 speed on the tree. Do you still have the parts listed? If so how much for the clutch Z bar? Jim Walsh

Hi: I need the corner trim pieces by the rear window on the rear deck for a '64 270 conv. These connect the stainless strips that contain the snaps at the base of the top. I also need one of the 9" Stainless pieces that go down the rear fender. I think the 63 and 64 pieces are the same. I can...