I have a 73 Valiant disc brake setup on my 67 Dart and would like to use a set of 2007 charger wheels. However, the center of the rotor is a 1/8 inch too big and won't completely slide into the wheels.
Does anyone know if there are other rotors that aren't quite so beefy that will bolt on...
My mopar buddy here said it wouldn't matter if I tied into the blue/yellow wire with the run wire just before the ballast resister and the same for the start ignition wire?
Is it important to connect them at the ballast resistor, or can you connect them anywhere prior to the ballast resistor? This is the only thing I am doing different?
Yes, it's a new mopar ignition with the 2 terminal ballast resistor.
It is wired like this.
Wire from negative side of coil to electronic control box.
Hot Start wire to ballast resistor and then to positive side of coil.
Run/Hot wire to other side of ballast resistor to control box...
Hey guys I've just spent the last 2 months swapping a slant six for a 383 in my 67 Dart. Today I finally received and installed my new schumacher headers and now when I tried to start the car it will start but will not run?
I am using a new electronic distributor, box, and resister. I have...
I'm sure this has already been asked, but I have a 67 Dart that has already been converted from drum to 5 x 4" discs. I am wondering if I can change the lug pattern from 5 x 4" to 5 x 4.5" to match the 8 3/4 rear end by simply buying a different rotor and bearing set off of a 72/73 A body?
That's what I thought. Thanks for the clarification. One of the local boys at Auto-zone said that it did, but I couldn't see how with the starter/fly wheel configuration... What Trans or combo should I be looking at. Don't need anything too hot, but would like to replace the slant six.
I like it... It makes sense. I just traded my old 65 Chevy truck for a almost all original 67 Dart 2 door sedan but don't see a lot of them on the internet...
Does anyone know if there is a title/name/category for the difference between the 2 door Dart with the window post between the front door and side/back window and the ones without?