I brought the duster out to my parking lot and did a nice little burnout. It didn't instantly break, so that is a good sign. Now it’s time to wet sand and add more clear for a deap shine.
Well i got the car started up today. It runs great. I have to bleed the brakes, adjust the rear suspension, and loom the harness wires. then it gets a low speed test drive in parking lot. I was able to modify the stock /6 auto shift linkage to fit the 46rh. I also included photos of the od and...
If your looking for the prndl and overdrive/lock up connectors, here is where to get them.
Overdrive/ converter lock up connector
EFI connection, Part #: 100-00334. PACT sells this same connector for twice the price.
Camshaft Position Sensor Connector Pigtail
PRNDL connector
ACDelco...
I started mocking up the exhaust today, but I needed to stop until i acquire some hangers. I decided to ditch the 3 bolt header flanges and use V-bands. I am putting the mufflers at the rear, most likely using borla xs mufflers. I also installed a cheapie ebay radiator. I finished up the rear...
Yes sir, I dumped the ram airbox. I don't recommend using one on a stock firewall if your after aesthetics. I have a factory a/c box and wiring, but I couldn't find a replacement a/c firewall. I ended up installing a non a/c firewall. I plan to purchase the Classic Auto Air kit. I will create an...
Well finally dropped some paint on the body. I painted all the backsides of the body panels too. Next step is to color sand the paint and spray the interior of the trunk and passenger compartment.
Well after finishing a ton of other projects, I finally decided to dust (pun intended) off this project and finish it. I bought a 2 post lift to make my life easier. I decided to go back to a stock firewall and use a carburetor instead of fuel injection.