Recent content by labyerly

According to the catalog, these fit '73 thru '76 Swinger

The sail panel box is 14"x51"x4" and weighs 5 pounds so you can calculate the shipping thru UPS.

A set of "new in the box" tan sail panels. If tan doesn't work for you, you could just remove the cover and replace with your color. These came from Dante's. $30 plus actual shipping (the box is pretty big) - probably UPS. Also have a premo set of sun visors. Although they are used...

Bless my wife's heart - she talked me into pulling the car from eBay. She may not really like the car - too fast, too much noise - but she understands that a muscle car, a street rod and an antique are the 3 kinds of cars every guy needs! Like I said, a future "barn find" for someone since my...

Thanks for the bump. The eBay auction ends tomorrow night and I just hope someone buys it. I'm trying to free up garage space for my '50 Plymouth street rod (frame finished and mating body to frame next weekend) but if it doesn't sell, it isn't the end of the world. I'll just shuffle cars...

How about a reasonable offer? Its going to go somehow/somewhere so it might just as well go to an "A Body" member.

Suspension: PST sway bars – 1” Front; 7/8” Rear Tie Rod Ends/ Ball Joints//Idler Arm Wheel Bearings KYB Gas-A-Just front and rear shocks CAP Automotive Tubular Upper A arms - probably should be replaced based on comments Mancini Racing lower control arm reinforcements...

Back on. The guy came by this morning to pick it up and made the mistake of bringing his wife along. She saw my Chevy show truck and informed him that she WANTED and would have the truck. Being the macho husband - like all of us - he said "yes, dear" and that was that. The show truck is gone...

Long gone - 1 day - thanks.

Over $7,000 in receipts - dynoed at 435HP - needs a new owner. I'm a street rodder - not a hot rodder and need to get after my '50 Plymouth coupe project. The car needs a paint job and proper seat covers. Almost everything else is new or fixed. Little or no rust - western car. If you PM me...

I clip and cap them off about 4" from the fuse box. The unused wire gets spooled up and put in a coffee can (the kind with a plastic top) and the can is labeled for the car the extras came from. When I need to add a device back in, I pull the proper wire out of the can and put it in place. If...

There's always the next project. To my mind, the building is more fun than the owning.

I thought I would update this for others like me. The REM headliner/sail panels are NOT really that wonderful. The covering is foam backed and ends up being kind of "puffy". The same is definetly true of the sail panels. The original sail panels had an almost paper like covering and the...

I've used 3 EZ-Wiring kits in cars (2 bucket T's and an Excaliber kit car) and have been totally satisfied - good phone tech support. I did try a Painless in one and it was just too expensive considering the competition. My '50 Plymouth came with a Francis setup and I think I'd still just...

I installed my new abs headliner for my '74 Dart Swinger. Purchased from Dante's manufactured by REM. HEADS UP to newbies like me: Precut holes in the plastic did not line up properly. The seatbelt holes were off by 3 inches and I didn't discover it until I put a bolt slit in the liner at...