Recent content by ldtc

thanks for the help guys just wanted to make sure the gaskets would work ok. I have not used these gaskets before and the two different sides threw me off.

i got some felpro head gaskets part#1008 the gaskets fit fine on one side i believe it was the drivers side but i had to flip the other gasket over to make it fit on the passenger side this is the only way it would line up with the dowel pins. Does this sound correct? The drivers side has the...

especially with 2 full bottles starring back at me from the top shelf in the garage!!!!!!

i just want something that will last, dont ever know when the urge to add nitrous will hit!!!!

i live near hickory nc does anyone know of someone capable of running a mopar engine on a dyno near my area, everybody i talk to either does ford or chevy. Small block 408 stroker.

does anyone know if they make a head gasket for a 360 bored 30 over , I have built a 408 stroker with eagle kit and need help with the head gasket selection. I cannot seem to find gaskets for a 4.030 bore. If not what else can i use. Would like something like MLS something durable. I have a set...

do you know of a good fan to use i dont have much room between the radiator and water pump pulley, prefer an electric fan i will measure the radiator core asap

just when idling in traffic or at a stop light at a busy intersection, does fine in clear traffic

Does anyone have suggestions on base timing for this combination or what springs to use for the mechanical advance, dist has no vacuum advance by the way, also what stop bushing are you guys using with these. I am running the mopar performance " .509 " cam with a set of rhoades original lifters...

408 stroker engine with edelbrock rpm heads, rpm air gap intake manifold, aluminum radiator, and electric cooling fan 180* thermostat, evans npg coolant. This car has run hot from day one since i swapped from slant 6 to v8. I have tried numerous different radiator and fan configurations does any...

i finally got my engine back in my 70 dart , new holley 750 vacuum secondary carb , 408 stroker with edelbrock rpm heads and rpm airgap intake, mopar performance cam, carb seems to be very lean at idle, any suggestions on settings for this carb, idle mixture screw settings? main jet sizes? power...

Thanks guys

I have a 70 dart swinger with a 408 stroker, do you guys have a carb recommendation and jet sizes,adjustments, etc for this setup. auto trans, 3000 stall conv,.508 lift cam, with rhoades "original" lifters

are all of the main bolts the same on a 360la or are there different ones for oiling purposes?

1970 dodge dart swinger 408 stroker , eagle forged crank rods and pistons engine is disassembled will need to be built, tci trans reverse manual valve body,8/34 rear axle with auburn limited slip, car is painted sunfire yellow with a black bumblebee stripe and black interior w/front bucket...