Recent content by low_kota

I used IGN2 - the blue wire on the 86 pin and it works.

Do you have IGN1 or IGN2 going to the 86 pin? I'm about to install a sniper using my factory wiring and ignition system.

Bump

Looking for a set of tail lights with nice bezels and a tail panel moulding for my 74 swinger. The pic attached is for reference, not my car. Please send pics and a price shipped to 63026 or I can pick up close to Fenton, MO. Thanks!

It turned out to be a loose connection at the ammeter.

Thanks for all the replies! I tried grounding the the terminal for the NSS on the starter relay, and nothing. I have 0V at the coil in start and run I also had a spare ballast resistor and swapped that out with no luck. The car doesn't have seatbelts in it, and has started several times...

I'm hoping you electrical gurus can help diagnose my problem. I just got the motor back in my dart and it ran awesome for about an hour! I started it at least 5 times, but now I turn the key and get nothing. I've done a ton of reading on the forum and did a few tests. I tried grounding the...

Here's how my car sits now. I'm going from sbp to bbp and the next step in my plan is to put the front suspension back together so I can move the car around. I have all the suspensions parts and disc brake conversion kit. Also swapping out the 7.25 for and 8.25 rear end.

I have searched, that's how I came up with the combo listed above. I have not seen anyone ask the same question that I have, if you can point me to the thread with answers to my specific questions, I would greatly appreciate it!

I need someone to double check my wheel and tire combo before pacing an order. My car's in a million pieces, so I can't really take any useful measurements for the foreseeable future... Trying to collect as many parts as I can before it warms up. For the wheels, i'm planning on cragar soft 8's...

It will be a while before I get it all installed, but I ordered a Holley sniper 2300 and a tanks inc. EFI tank and fuel pump.

Thanks! Gave me an excuse to get the tanks inc kit to go along with the sniper.

Looking good! Being from Missouri, my project cars always start with replacing the floors.... it would be awesome to start with something rust free.

Yes! We moved in April. I had a 1 car garage at the old house that couldn't fit my toolbox. Having the 3 car garage makes things a lot easier.

Here's one of my helpers removing parts before pulling the motor.