Recent content by Man-on-wheels

Very nice, Mike69barracuda! Those look great for a great price! I appreciate that but we've abandoned our Dart project, it ended up having too much rust. We haven't decided if we're going to try to find another car or use the money that we have to go ahead and build the engine. The problem...

No problem DDemon! Thank you and good luck on finding what you need!

Ok Kim, according to the UPS shipping calculator it's going to cost right at $50.00 for the shipping. However, if you've had any experience using the shipping calculator you know that the true shipping cost usually ends up being a little higher so I wouldn't be surprised if it's more like...

Sounds good oldkimmer. As soon as he gets the measurements I will use the UPS shipping calculator to get you an estimate. Thanks for your patience and have a great day! -Kris-

oldkimmer, let me check it out and get an estimate on the shipping cost. Please be patient with me because I am quadriplegic so I'll have to get my brother to measure and weigh the box. And to be perfectly honest with you, he's pretty busy. I'll git-r-dun ASAP. Thanks and have a great day!

Yeah 1969GTS340, I would sell it separately. $250.

Yes DDemon, it is mild steel.

Hello everybody, Up for sale is a brand new and still in the box 8 point roll cage for any Mopar A-body made by competition engineering and also a brand new set of summit racing 24 gauge steel wheel tubs that are 36"L X 23.25"W X 18"T and are also still in the box. Asking $350 OBO for both...

Up for sale is this factory 318 1971 Dodge Dart project car. The body is straight, all of the glass is good, comes with the grill, headlights, bezels, a strait flat hood that's already drilled for hood pins, straight trunk lid and the bumpers. It has the back seat but no front seats, the...

Yeah, that is right where I want it to be for a hydraulic flat tappet camshaft. Which like I said, is probably the route we will go. I would really love to get a set of those Indy EZ-1 CNC ported cylinder heads that have 275 cc intake runners and the combustion chambers are 75 cc which with...

Thank you for the advice IQ52! I made a mistake on what I said though, I actually have two complete separate builds planned. The first being a mid to high 11's which would consist of a .030 bored block with the stock steel crank and rods, forged flattop pistons, cut the deck and/or mill the...

Hello everybody, Great information on the comparison of these different casting number heads. My brother and I bought a 1978 440 out of a Chrysler new Yorker. We haven't disassembled it yet but I'm assuming it has the 452 heads. What I'm trying to find out is how many CC's the combustion...

Hey everybody, I know that on any rear end if you turn one tire and the other one turns the same way then it's a posi. What I don't remember is if it matters whether or not the drive shaft is installed. I'm just trying to find out if the 8 3/4 in the Dart we bought is a posi. It took just...

Thank you all for the input... I appreciate it! I've never cared for the snorkel scoops Big-B-Barracuda but the six pack hood scoop would look nice. However, I still like the super stock better! We haven't quite decided on how rowdy of a 440 we're going to build, if we decide to make it a...

Awesome! Thank you all so much! :-)