Recent content by manderson1356

Also the test light I currently have has got a led bulb in it, should I exchange that for a conventional bulb?

So after doing some more digging around with a test light, I determined that there was in fact an issue with the turn signal switch/cam. I replaced the cam and got the signals back for a brief moment before the cheap replacement part broke on me, and even when it was working I needed to fiddle...

On a side note, should I move away from glass fuses? I assume it would just involve replacing the ends of the wires and then finding a way to secure it all together yeah?

Both my flasher/hazard relays are on the drivers side above the fuse box, and I have not had the grill off lately, but I would figure if the ground wire was busted the hazard lights wouldn't flash either right?

Fuses are intact, unless it went in such a way where I can't see it.

Early 1976 Dodge Dart base sedan, I'll start this off with this, I'm looking for advice on a "do the wrong thing, the right way" sort of fix, I'm working with the combo of having a tight budget and very little electrical experience. With that said my turn signals have quit on me, bulbs are good...

Thanks for the info everyone, I’ll do some investigation and hopefully I’ll get it sorted out, here’s to hoping the filler neck isn’t mangled.

The gas cap that’s currently on my 76 dart seems like it doesn’t quite fit right, it’ll spin endlessly with a snug spot at about a 45 degree angle to the trim line below, the cap is one of those chrome with black plastic block handle. I’m just wondering if this is normal, and if it’s not I’d...