Trying to make the fuel gauge work on my newly acquired 65 Dart . I have had the dashboard out and the gauges restored by D&M restoration in South Carolina. They fixed the burnt out voltage regulator and repaired the speedo. There is a new fuel sender, which I have grounded. The gauge will...
My recently acquired 65 Dart GT has an aftermarket Offenhauser intake manifold and a stock Carter BBS carb. The Offy intake does not have a provision for a (divorced) choke as a result the choke plate is just flopping around. Is there a common solution to this issue? I was thinking and...
I looked at the car this morning and the brown wire is screwed into the body behind the kick panel. This loose wire (actually two wires in the eyelet) has been just flopping loose on top of the heater box. It should screw down somewhere - but I don't see where. Any suggestions?
I have a 65 Dart and I am replacing the broken heater blower motor. When I removed the heater box I noticed that some wiring was hanging loose. I thought I could figure it out as I had a wiring diagram http://www.mymopar.com/downloads/1965/65DartA.jpg for the car.
My problem is the diagram...